NF560-A2G/NF520-A2G
1
CHAPTER 1: INTRODUCTION
1.1 BEFORE YOU START
Tha nk you for choosing our pro duct. Be fore you sta rt installing the
mothe rboa rd , please make sure you fo llow the instru ctions be low:
Prepare a dry and stable working environment with
s ufficie nt lighting .
Always disconnect the computer from power outlet
befo re ope ra tion.
Befo re you take the mo the rboa rd ou t f rom a n ti-s ta tic
bag, ground yourself properly by touching any safely
grounded appliance, or use grounded wrist strap to
remove the static charge.
Avo id tou ching the com pone nts o n mo the rboa rd o r the
rear side of the board unless necessary. Hold the board
on the edge, do not try to bend or flex the board.
Do not lea ve any unfastened sma ll parts inside the
case after installation. Loose parts will cause short
circuits which may damage the equipment.
Keep the computer from dangerous area, such as heat
source , humid a ir and water.
1.2 PACKAGE CHECKLIST
HDD Cable X 1
Se ria l ATA Cab le X 1
Rear I/O Panel for ATX Case X 1
Use r’s Manua l X 1
Fully Setup Driver CD X 1
FDD Cable X 1 (optional)
USB 2.0 Cable X1 (optional)
S/P DI F ou t Ca ble X 1 (optiona l)
Note: The package contents may differ by area or your motherboard version.
To Next Page
Loading...
