P4M890-M7 SE
3
CHAPTER 1: INTRODUCTION
1.1 BEFORE YOU START
Tha nk yo u fo r choo sing our pro duct. Be fo re you sta rt installing the
mo the rboa rd, plea se make su re you fo llo w the instructio ns be lo w:
Prepare a dry and stable working environment with
s ufficie nt ligh ting .
Always disconnect the computer from power outlet
be fore ope ra tion.
Befo re you take the mo the rboa rd ou t f rom a n ti-s ta tic
bag, ground yourself properly by touching any safely
grounded appliance, or use gro unded wrist strap to
remove the static charge.
Avo id tou ch ing the compone nts o n mo the rboa rd o r the
rear side of the boa rd unless necessary. Hold the boa rd
on the edge, do not try to bend or flex the boa rd.
Do not lea ve any unfastene d small parts inside the
case after installation. Loose parts will cause short
circuits which ma y damage the equipment.
Keep the computer from dangerous area, such as heat
source , humid air and wa te r.
1.2 PACKAGE CHECKLIST
z HDD Cable X 1
z Use r’s Manua l X 1
z Fully Setup Driver CD X 1
z Rear I/O Panel for ATX Case X 1
z FDD Cable X 1 (optional)
z Se ria l ATA Cab le X 1 (op tiona l)
z USB 2.0 Cable X1 (optional)
z S/PDIF Cable X 1 (optional)
z Se ria l ATA Po we r Cab le X 1 (o ptio nal)
To Next Page
Loading...
Need help?
General
