BIRO Mini-32 - Gear Reducer Lubrication and Oil Changes

11
LUBRICATION CONTINUED FOR GEAR REDUCERS
1. Factory Filling
The speed reducer is lled with Mobil Glygoyle 460 polyglycol (PAG), to the proper level for the standard mounting
position. The oil level should be checked and adjusted (if necessary) prior to operation, using the oil level plug
provided and while the unit is oriented in its operating position.
2. Oil Changing
OIL SHOULD BE CHANGED MORE OFTEN IF THE
REDUCER IS USED IN A SEVERE ENVIRONMENT
(i.e., DUSTY, HUMID)
Therefore, if changing to a different oil, it is recommended that the housing be completely drained and thoroughly
ushed with a light ushing oil prior to relling with the appropriate lubricant. The oil level should be rechecked
after a short period of operation and adjusted, if necessary.
A. Initial Oil Change
The oil in a new speed reducer should be changed at the end of 100 hours of operation.
B. Subsequent Oil Changes
Under normal conditions, after the initial oil change, the oil should be changed after every 2500 hours of operation,
or every six months, whichever occurs rst. Under severe conditions (rapid temperature changes, moist, dirty, or
corrosive environment) it may be necessary to change oil at intervals of one to three months. Periodic examination
of oil samples taken from the unit will help establish the appropriate interval.
C. Synthetic Oils (NOTE: Gearbox comes standard with Synthetic Oil).
3. Overlling or Underlling
If a speed reducer is overlled with oil, the energy in churning the excessive oil can result in overheating. If this occurs,
shut down the drive, remove the oil level plug and allow oil to drain until oil ceases to drain from the level hole,
reinstall the oil level plug and restart the drive. If the speed reducer is underlled, the resultant friction can cause
overheating and possible damage. If this occurs, ll the speed reducer to the oil level plug hole and check the gearing
for excessive wear. NOTE: Oil capacity is approximately 40 ounces.
4. Oil Seals
A. When installing a new seal, cover the keyway and any other surface discontinuity with smooth tape to protect the
seal lip from being damaged.
B. A sealant should be used between the O.D. of the seal and the I.D. of the bore into which the seal is installed. The
seal bore should also be free of any burrs, nicks, or scratches.
C. Be sure that the seal is not cocked in the bore. The outer face of the seal should be ush with the surface into which
it is mounted.
WHEN CHANGING OIL FOR ANY REASON,
DO NOT MIX DIFFERENT OILS IN THE REDUCER.
OILS SHOULD BE COMPATIBLE WITH
VITON SEAL MATERIAL.
®
Synthetic lubricants can be advantageous over mineral oils in that they generally are more stable, have a longer life,
and operate over a wider temperature range. These oils are appropriate for any application but are especially useful
when units are subjected to low start-up temperatures or high operating temperatures. For continuous duty
we recommend the use of Mobil Glygoyle 460 polyglycol (PAG).
Although the speed reducer uses high quality oil seals and precision ground shafts to provide a superior seal contact
surface, it is possible that circumstances beyond the speed reducer’s control can cause oil seal leakage (damage during
shipment or installation, etc.) When replacing a shaft oil seal, using the following suggestions will help to insure leak-
free operation and long seal life: