BIS TRADITION - The Fireplace; 3.1 Introduction to the Fireplace; 3.2 Operating the BIS TRADITION

4
3. THE FIREPLACE
3.1 INTRODUCTION
The BIS TRADITION fireplace is an energy efficient, heat circulating, close combustion
fireplace. You will receive a lifetime of comfort and enjoyment from your fireplace provided
it is installed, maintained and operated properly.
• Please read these instructions and retain this manual for future reference.
• Before beginning the fireplace installation, consult the local authorities to obtain your
building permit and check your local building codes. Install the fireplace only as
described in these instructions and using only Security Chimneys International
components.
• The BIS TRADITION is not intended for use with a gas log. Failure to follow these
instructions will void the certification and the warranty of the fireplace and may result in
an unsafe installation.
3.1.1 Parts Required
• Fireplace model BIS TRADITION
• Door kit
• Front facing kit
• UZY5 fan (included in the fireplace). Electrical hook-up in junction box must be done
BEFORE the installation of the façade.
• 7" diameter chimney model Secure Temp
S-2100+
, Nova Temp
HT6000+
, Secure Temp
GX
(U.S.
only) or ACBI manufactured by Security Chimneys International only, including:
- Chimney lengths
- Elbows (where necessary)
- Associated components as per these installation instructions
• Outside air kit. (included)
3.1.2 Additional Equipment (optional)
• 5" flexible venting system (central forced air kit - not EPA approved) (see section 3.5.2)
• Gravity venting system (see section 3.5.1)
• TUBINOX chimney ( or PROJET SS), 7” diameter with adaptor for installation in a
masonry chimney.