SRP-275II
Rev. 1.05
5-2-1 Send Commands
The Windows driver serves to receive the content for print from an application and send it
to the printer. The Send Commands function allows for the addition of desired commands
at the start or end of the print content.
Addition of command at the beginning of the document.
Addition of command at the beginning of the page.
Addition of command at the end of the page.
Addition of command at the end of the document.
For more information about the hexadecimals that can be entered in “Start Doc”, “Start
Page”, “End Page” and “End Doc”, refer to the Commands Manual.
5-2-2 Cash Drawer
To open a cash-drawer before printing, tick “Open before printing #1” or “Open before
printing #2” in the “Cash Drawer” and then click “OK”.
To open a cash-drawer after printing, tick “Open after printing #1” or “Open after printing
#2” in the “Cash Drawer” and then click “OK”.
5-2-3 Line Feed
Enter the number between 0 and 99 for adding blank lines at the end of printing.
5-2-4 Paper Cut
Paper can be cut at the end of each page or each document (job).
Page/Job : No Cut / No Cut
Paper is not cut after printing.
Page/Job : No Cut / Partial Cut
Paper is cut at the end of each document (Job).
Page/Job : Partial Cut / Partial Cut
Paper is cut at the end of each page.