Rev. 3.02
- 11 -
SRP-350
2-2 Operation
2-2-1 Setting the DIP switches
The DIP switches are located on the bottom of the printer. The DIP switches are used to set the printer to perform various
functions. Follow these when changing DIP switches setting:
1. Turn the printer power switch off.
2. Remove the screw on the bottom of the printer and open the
bracket.
3. Flip the DIP switches using tweezers or another marrow-ended
tool. Switches are in when up and off when off down.
4. The new setting takes effect when you turn on the printer.
※ Note : Always change DIP switch settings only when the
printer is turned off. Change made with the power on
have no effect and then on again.
Figure 2-5 Setting the DIP switches
2-2-2 Setting the DIP switch (RS-232C Serial Interface)
• DIP Switch 1
SW Function ON OFF Default
1 Auto Line Feed Always enabled Always disabled OFF
2 Reserved - - OFF
3 Handshaking XON/OFF DTR/DSR OFF
4 Word length 7 bits 8 bits OFF
5 Parity check Yes No OFF
6 Parity selection EVEN ODD OFF
7 ON
8
Baud rate selection Refer to the Following Table 1
OFF
• DIP Switch 2
SW Function ON OFF Default
1 Code Page Selection Refer to the Following Table 3 OFF
2 Internal bell control Internal bell disable Internal bell enable OFF
3 Auto Cutter Selection Disable Enable OFF
4 Code Page Selection Refer to the Following Table 3 OFF
5 OFF
6
Select Print Density Refer to the Following Table 2
OFF
7 Near End Sensor Status Disable Enable OFF
8 Code Page Selection Refer to the Following Table 3 OFF
To Next Page
Loading...
Need help?
General
