BIXOLON SRP-E300 - Page 27

SRP-E300/E302
Ver. 2.00
- 27 -
(2) If “VMSM Selection” is selected
The following lines will be printed when the VMSM opens.
** VMSM Selection **
0 : Exit and reboot printer
(*) 1 : None
2 : Set Print Density
3 : None
4 : Set Cutting mode
5 : Set External Buzzer after
cutting
6 : None
7 : None
8 : Print current settings
9 or more : None
(*) SRP-E300ES/E302ES
1: Ethernet Information Setting
Press the Feed button to run the above function.
Step 1(Select Options): press the button a number of times as shown by each
menu.
Step 2(Enter Options): hold down the button for at least one second to apply
each item selected.
- If you select any items not listed above, the list of “VMSM Selection” will be
printed
again. Setting the mode will be canceled if no item is selected in Step 1.
- If the "0: Save settings and exit" function is not executed,
The setting information is not stored in the printer.
Hold down the Feed button for at least 1 second to save the changes.
The following line will be printed before cutting the paper.
*** COMPLETED ***
6) The new settings will be automatically applied when printer resets.