EasyManua.ls Logo

BIXOLON SRP-E300ESK - Drawer Port

BIXOLON SRP-E300ESK
25 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Ver. 1.00
- 9 -
SRP-E300/E302
1-3 Drawer Port
Connect the cash drawer connection cable to the drawer kick-out connector on the rear side
of the printer.
- SRP-E300/E302 - SRP-E300ES/E302ES
Pin No.
Signal Name
Direction
1
Frame Ground
-
2
Drawer Kick-out Drive Signal 1
Output
3
Drawer Open/Close Signal
Input
4
+24V
-
5
Drawer Kick-out Drive Signal 2
Output
6
Signal Ground
-
Caution
- Use a cash drawer that meets the printer specifications.
Using a cash drawer that is inappropriate to the specs or using
it as a power supply for a separate device may result in
damage to the product
- Do not connect a telephone line to the drawer kick-out
connector. Otherwise, the telephone line and the computer
may be damaged.
- Do not allow a foreign object such as a conductor to touch
the cash drawer port. This may result in damage to the product
- Make sure to use a cash drawer with an internal coil resistance of
24 or higher. (The maximum current is 1A.)
- The open signal time for the cash drawer should not exceed 0.8
seconds. After opening the cash drawer, make sure to idle for at
least 3.2 seconds (at least 4 times that of the open signal time)
before operating it.
Drawer(DK) Port
Drawer(DK) Port

Related product manuals