51
OPERATION INSTRUCTIONS
Data Hold/Trigger Hold
The data hold/trigger hold function allows the user to freeze
the display when pressed, holding the measured value until
data hold is turned off.
Turn On Data Hold
To use data hold, press the button once. The “DH”
indicator will display on the screen when data hold is active.
Trigger Hold
Users can send a trigger hold once data hold has
been turned on. While “DH” indicator is displayed, all
subsequent key press of the
button will send a
trigger to acquire a reading and hold immediately.
Turn Off Data Hold
To disable the data hold, press and hold button for
two seconds. The “DH” indicator will disappear on the
screen, and meter will turn to normal operation mode.
To Next Page
Loading...
Need help?
General
