13
Front Panel Display Descriptions
1. LCD Display
2. Power ON/OFF Button
3. USB Communication / *Back light button
4. Secondary Display mode (for dissipation
factor(D), quality factor (Q), *phase angle (θ),
*equivalent series resistance (ESR)
measurement) selection button
5. Primary Display mode (for inductance,
capacitance, resistance, and *impedance
measurements) / Parallel or Series
measurement method selection button
6. Tolerance mode / Utility down arrow selection
button
7. Hold Display mode / Record mode selection
button
8. Utility menu button
9. Test Frequency / Utility up arrow selection
button
10. Relative mode / Calibration mode selection
button
11. 12V DC adapter input (use with an external
power adapter (rated 12VDC, 150mA, 4mm
power plug))
Note: Use with included power adapter only.
Use with improper power adapters may
damage instrument.
To Next Page
Loading...
