BK Precision 9801 - Page 18

Query syntax: CONFig:PROToct:CURRent:RMS:MODe?
Return parameter: <NRf>
CONFig:PROTect:CURRent:PEAK
This command is used to set the peak current protection point (Ipeak-Protect).
Command syntax: CONFig:PROToct:CURRent:PEAK <NRf>
Parameter: MIN TO MAX|MIN|MAX|
Unit: A
Query syntax: CONFig:PROToct:CURRent:PEAK?
Return parameter: <NRf>
CONFig:PROTect:CURRent:PEAK:MODe
This command is used to set the peak current protection (Ipeak-Protect) delay mode.
Command syntax: CONFig:PROToct:CURRent:PEAK:MODe <NRf>
Parameter: DELay | IMMediate
Query syntax: CONFig:PROToct:CURRent:PEAK:MODe?
Return parameter: <NRf>
CONFig:BNC[:PORT][:FUNCtion]
This command is used to configure the BNC terminal functionality.
Command syntax: CONFig:BNC[:PORT][:FUNCtion]<NRf>
Parameter: I-TRigger|I-RI|O-PHase|O-ON
Example: CONF:BNC I-TR
Query syntax: CONFig:BNC[:PORT][:FUNCtion]?
Return parameter: <NRf>
CONFig:DIMMer:MODe
This command is used to configure the dimmer mode to either leading/trailing edge or off.
Command syntax: CONFig:DIMMer:MODe <NRf>
Parameter: LEADingedge|TRAilingedge|OFF
Query syntax: CONFig:DIMMer:MODe?
Return parameter: <NRf>
CONFig:LIST:STARt:MODe
This command is used to configure the mode to start/initiate a list program. This controls the
List-Set setting in the menu.
Command syntax: CONFig:LIST:STARt:MODe <NRf>
Parameter: ON/OFF | TRIGGER
Example: CONF:LIST:STAR ON/OFF
Query syntax: CONFig:LIST:STARt:MODe?
Return parameter: <NRf>