6 7
GETTING TO KNOW YOUR CONTROL PANEL
BEFORE BREWING
PROGRAMMING YOUR COFFEE MAKER
1. To register your product, go to www.prodprotect.com/blackanddecker
2. Carefully unpack your coffeemaker, removing all packaging materials, labels, and/or
stickers from your coffeemaker.
3. Remove the plastic band around the power plug using scissors
4. Clean your coffeemaker thoroughly before using for the first time. Wash the thermal
carafe and washable brew basket in warm, soapy water. Rinse and dry, then place
back into your coffeemaker.
5. Clean the inside of your coffeemaker by running two full brewing cycles with water
only, no coffee.
a. Pour fresh, cold water into the water reservoir up to the 12-cup MAX
mark, then place carafe onto the carafe plate.
b. Plug cord into standard electrical outlet.
c. Push the ON-OFF / Power Button to immediately brew water through
the coffeemaker without adding coffee.
d. Once the cycle is finished, discard water.
e. Turn off appliance, unplug and allow to cool down for 15 minutes
before repeating.
Setting the Digital Clock
1. Plug the coffeemaker into a standard electrical outlet.
2. The digital clock display flashes “12:00”.
3. To set the time, press the HR button until the correct hour appears on the
display. The “PM” symbol will appear in the upper right corner of the digital
display for PM time settings.
4. Press the MIN button to select minutes.
Note: If the unit is unplugged or power interrupted, the time will need to
be reset, as will the Brew Later delay start time.
Setting the Brew Later Delay Start for the first time
The programmable Brew Later delay start allows you to set the 24-hour timer
to brew coffee at the selected time, day or night. To activate the Auto Brew
timer, follow these steps
:
1. After the digital clock is set, press the BREW LATER button. The programmed
clock time will begin to flash.
2. BREW LATER displays and flashes.
3. Clock shows last BREW LATER time programmed (if no time has been
programmed, or unit has been unplugged, BREW LATER time defaults to 12:00)
Digital Clock with
LCD Display
Strong display
When showing,
indicates that the
strong mode is set.
Hour Button
Use to program the
clock
(see “Programming”
section)
Clean Button
For the auto clean
function
Brew Later Button
Use to program
(see “Programming”
section)
Power Button
Lighted button turns
the unit ON or OFF.
PM indicator
Shows when the clock
is set past noon.
Brew Later display
When showing,
indicates that the
Brew Later function
is set.
Minute Button
Use to program the
clock
(see “Programming”
section)
Strong button
Use to program
(see “Programming”
section)
To Next Page
Loading...
Need help?
General
