7
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
CHAPTER 1: OVERVIEW
TABLE 1-6. POE MODE LED INDICATORS
LED
COLOR STATE DESCRIPTION
RJ-45 Ports
Green On The port is enabled and supplying power to connected device.
Amber On An abnormal state, such as overload status, has been detected in the switch.
Off Off
The port has no active network cable connected, or it is not connected to a PoE PD device. Otherwise,
the port may have been disabled through the switch user interface.
1.3.4 MODE/RESET BUTTON
Press the Mode/Reset Button for a certain period of time to perform the following tasks.
Change Port Status LED Mode: Read the port status correctly in the two different modes (Link/Act/Speed mode or PoE mode).
Reset the Switch: Reboot and get the switch back to the previous configuration settings saved.
Restore the Switch to Factory Defaults: Restore the original factory default settings back to the switch.
NOTE: According to the next table, users can easily judge which task is being performed by reading the LED behaviors while pressing
the Mode/Reset button. Once the LED behaviors are correctly displayed, release the button.
TABLE 1-7. MODE/RESET BUTTON DESCRIPTIONS
TASK TO BE PERFORMED
TIME PERIOD TO PRESS
THE BUTTON
SYS LED BEHAVIOR PORT STATUS LED BEHAVIOR
Change LED Mode 0 to 2 seconds On Green LED status will be changed according to the mode selected.
Reset the Switch 2 to 7 seconds Blinking Green ALL LEDs Light OFF
Restore to Defaults 7 to 12 seconds Blinking Green ALL LEDs Stay ON
To Next Page
Loading...
