BLACKSTONEPRODUCTS.COM
ENGLISH
| OWNER’S MANUALTROUBLESHOOTING
STEP 01
Remove the turntable.
STEP 02
Use compressed air to blow out the burner scallops. (Wear
eye protection)
STEP 03
Remove the bolt and burner cap.
Note: DO NOT disturb the ignitor needle or thermocouple
while cleaning.
STEP 04
Clean the inside of the burner:
• Run a narrow bottle brush through the burner several times. (DO
NOT use wire brushes)
• Use compressed air to blow out the burner. (Wear eye protection)
STEP 05
Replace burner cap and bolt.
If problems persist, contact customer support.
STEP 02
❶
Remove the base panel cover
from the base of the unit.
❷
Disconnect the orifice
nozzle and gas line from the
burner tube.
STEP 03
Use compressed air to
clear the burner tubes.
Note: Once reinstalled, the
gas line should be leak tested
to ensure there are no holes
in the line.
⚠
The gas rail fuel nozzle
must be reengaged within the
burner opening.
VIDEO TUTORIAL
Pizza Oven Troubleshooting
CLEANING THE BURNER ASSEMBLY
⚠ CAUTION
All cleaning and maintenance should be carried out when the
appliance is cool and with the fuel supply turned OFF at the
gas cylinder.
Spiders and insects can nest within and clog the burner/venturi tube
at the orifice.
Spiders and insects can nest within and clog the burner/venturi tube
at the orifice. To reduce chance of “flash-back” the procedure below
should be followed at least once a month when spiders are most
active or when your appliance has not been used for a period of time.
CLEANING THE BURNER ASSEMBLY
⚠ CAUTION
All cleaning and maintenance should be carried out when the
appliance is cool and with the fuel supply turned OFF at the
gas cylinder.
STEP 01
Run a nylon brush over
the outer surface of the burner to
remove grime.
⚠ WARNING
A clogged burner can
lead to a fire beneath the
appliance.
Burner should be removed
and cleaned whenever
blockages are found.
❶
❶
❷
BoltBoltBurner capBurner cap
Ignitor Ignitor
needleneedle
ThermocoupleThermocouple
Fuel nozzle
Burner opening
MODEL: 2379
To Next Page
