34
SERVSWITCH™ SPECTRA
4.2 Select a CPU or Switch to the Other CPU
If you know which computer you want to access (CPU 1
or CPU 2), enter the “Select CPU” command: Press and
release your keyboard’s left Control key ([Ctrl]), then
press and release that CPU’s number key at the top of
the keyboard ([1] for CPU 1 or [2] for CPU 2). The
ServSwitch Spectra will immediately switch to that CPU.
If you want to switch to “the other computer” (the
one you’re not using right now) but you’re not sure
what its number is, enter the “Switch to the Other CPU”
command: Press and release the left Control key
([Ctrl]), then press the [Backspace] key.
You can always, of course, select either CPU
by pressing the button on top of the Spectra.
4.3 Start/Stop Scanning
To make the ServSwitch Spectra start scanning
(switching continuously back and forth between the two
CPUs), press and release the left Control key ([Ctrl]),
then press and release [S].
As it scans, the Spectra pauses for 1 to 15 seconds at each
CPU. (You can set this “Scan-Delay Time”; see Section 4.9.)
To Next Page
Loading...
