40
SERVSWITCH™ SPECTRA
The “Identify ROM” command causes the Spectra to
send two numbers xy (short for its three-character “x.y”
ROM level) to the currently selected CPU as ASCII
keyboard data; these characters will be echoed back to
your monitor if you are at some type of prompt. (You
must be at some kind of prompt or screen capable of
displaying typed-in keyboard characters, or you will
not see the Spectra’s response.)
To enter the Identify ROM command, press and
release the left Control key ([Ctrl]), then press and
release [I].
4.8 Keep Settings
The “Keep Settings” command saves the current state of
the ServSwitch Spectra’s keyboard-selectable settings to
nonvolatile memory (NVRAM), where they become the
new default settings that are loaded when the Spectra is
powered up. To enter this command from your
keyboard, press and release the left Control key ([Ctrl]),
then press and release [K]. Two of the four keyboard-
selectable settings are described in the next two sections;
the others are described in Appendix C.
To Next Page
Loading...
