41
CHAPTER 4: Operation
4.9 Set Scan-Delay Time
Enter a “Set Scan-Delay Time” command to set how long,
in seconds, the ServSwitch
Spectra will pause at each of
the CPUs when it’s scanning them. The factory-default
setting is 5 seconds. To set a different delay time, press
and release the left Control key ([Ctrl]), then type the
letter [T] followed by the new delay time in seconds
(1 to 15), and press and release [Enter]. (If you enter
this command with an argument of zero, the Spectra will
set the scan-delay time to the default value most recently
saved in NVRAM.) Enter the Keep Settings command
after you enter this command.
4.10 Set Mouse Mode
Normally the ServSwitch Spectra outputs “plain-vanilla”
(non-wheel) PS/2 mouse data to the CPUs, regardless
of what type of mouse you’ve actually plugged into it or
what type of mouse port each of the attached CPUs has.
If either of the CPUs has a serial mouse port, you need
to tell the Spectra to do PS/2 to serial translation for
that CPU. With that CPU selected, enter the “Set Mouse
Mode to Serial” command: Press and release the left
Control key ([Ctrl]), then type the letter [Q] followed
by the number [1], and press and release [Enter].
To Next Page
Loading...
