42
SERVSWITCH™ SPECTRA
Similarly, if you’re using a PS/2 wheel mouse with the
ServSwitch Spectra, and either of the attached CPUs has
a PS/2 mouse port and is running a driver that will
handle wheel-mouse data, you should tell the Spectra to
output mouse data in PS/2 wheel format to that CPU.
With that CPU selected, enter the “Set Mouse Mode to
PS/2 Wheel” command: Press and release the left
Control key, then type the letter [Q] followed by the
number [2], and press and release [Enter].
If later you attach a computer with a PS/2 mouse port
and a non-wheel-mouse driver, and you want to return
to the standard mouse mode, enter the “Set Mouse
Mode to PS/2 Non-Wheel” command: Press and release
the left Control key, then type the letter [Q] followed by
the number [0], and press and release [Enter].
Enter the Keep Settings command after you enter any
of these commands.
To Next Page
Loading...
