Autodesk Smoke
Autodesk Smoke brings together editing, compositing and 3D effects into a single workspace.
Smoke captures and plays back standard definition and high definition video and audio with
Blackmagic Design video hardware and also supports RS-422 deck control.
Autodesk Smoke
Setting Up a VTR
Before starting Autodesk Smoke, you must use a utility called Smoke setup to select the model
of the VTR in your facility and its appropriate timing settings.
1 Go to Applications > Autodesk > Smoke 2018 > Utilities and open ‘Smoke Setup’.
2 In the ‘general’ tab, make sure that ‘video device’ and ‘audio device’ are set to ’BMD’.
3 In the VTR tab, enable the VTR model and the timings you want to use with Autodesk
Smoke. Enable the rows with live NTSC or live PAL to enable crash record or
live output.
4 Click ‘apply’ and close Smoke Setup.
Ensure ‘video device’ and ‘audio device’ are
set to BMD in the Smoke Setup utility.
51Using your Favorite 3rd Party Software
To Next Page
Loading...
Need help?
General
