ENGLISH
(Original instructions)
9
Once the appliance has been used:
♦ Stop the appliance by pressing button (A1) on/off
♦ Unplug the appliance from the mains.
♦ Unplug the appliance from the mains and allow it to cool
down before starting any cleaning operation.
CLEANING
♦ Wipe the appliance with a damp cloth impregnated
with a few drops of detergent. Do not use solvents or
products with an acidic or basic pH factor such as bleach
or abrasive products to clean the apparatus.
♦ Do not immerse the appliance or its plug in water or
other liquid or place it under the tap.
♦ If the appliance is not in good condition of cleanliness, its
surface may degrade and inexorably affect the duration
of the appliance’s useful life and could become unsafe
to use.
Storing the appliance:
♦ Switch off the appliance and remove the plug.
♦ Separate the exhaust pipe from the air and store it
carefully.
♦ Put the appliance in a dry place.
♦ Remove the batteries from the remote control and store
them carefully.
ANOMALIES AND REPAIR
♦ In the event of a fault, take the appliance to an author-
ized service center. Do not attempt to disassemble or
repair it as there may be danger.
♦ Any person who is involved with working on or breaking
into a refrigerant circuit should hold a current valid certif-
icate from an industryaccredited assessment authority,
which authorizes their competence to handle refrigerants
safely in accordance with an industry recognized assess-
ment specication.
♦ Servicing shall only be performed as recommended by
the equipment manufacturer. Maintenance and repair
requiring the assistance of other skilled personnel shall
be carried out under the supervision of the person
competent in the use of ammable refrigerants.
♦ If any fault is detected, refer to the following table:
Problem Causes Solutions
Product is not working There is no current.
Illuminated water ll indicator
Switch on device
Empty water tank
Start device after empty water tank
Seems device is not working Windows or doors are open
Dirty lter
Air inlet or outlet are block
Room temperature is lower than the
programated
Close doors
Close windows
Clean or change air lter
Clean container
Change temperature setting
Devide noise too loud Device is not in a at surface Change device in a at surface
Compressor is not working Overheat protection is activated Switch on device after 3 minutes, when
temperature is lower
Detection codes Meaning
E1/E2: Temperature sensor problem
FL: Water tank full
To Next Page
Loading...
Need help?
General
