Why Blade Toy helicopter will not initialize?
Your Blade Toy helicopter might not initialize due to the throttle being at a high position. To fix this, ensure the throttle trim is at the center or lowest setting. Another potential cause is improperly configured pitch or throttle servo reversing. In this case, reset the servo reversing.
What to do if Blade Toy helicopter will not bind properly to non-computer radio?
Binding to non-computer radios requires a slightly different approach. Release the bind button/switch after applying left rudder. Avoid holding the bind button/switch after applying left rudder.
Why does my Blade mCP X Toy helicopter vibrate in flight?
If your helicopter vibrates during flight, it could be due to damaged rotor blades, spindle, or blade grips. Replacing the bent spindle may resolve this issue.
What causes poor tail authority in Blade mCP X helicopter?
Poor tail authority can be caused by a warped or bent tail rotor blade. Replacing the tail boom or the blade itself may solve the issue.
What to do if climb out rate is greatly reduced in Blade mCP X?
If the climb out rate is greatly reduced, consider replacing the main gear or parts, or replacing a bent spindle.
Why Blade mCP X power decreases during flight?
If the power decreases during flight, recharge the flight battery or replace it if it is no longer performing optimally.
Lists essential safety guidelines for operating the helicopter model.
Explains the LVC feature and its role in protecting the Li-Po battery.
Instructions for binding with programmable computer transmitters.
Instructions for binding with basic transmitters like DX4e/DX5e.
General| Brand | Blade |
|---|---|
| Model | mCP X |
| Main Rotor Diameter | 245 mm |
| Power Source | Battery |
| Control Type | Radio Control |
| Skill Level | Intermediate |
| Battery Type | 1S 3.7V 200mAh LiPo |
| Flight Time | 5-7 minutes |
| Transmitter | Not Included |
| Motor Type | Brushed |
| Type | Helicopter |
| Charging Time | 30 minutes |
To Next Page
