Blade mCP X - Installing the Flight Battery; Flying the mCP X

10
EN
1. Lower the throttle and throttle trim to the lowest settings.
2.Poweronthetransmitter.
3.Installtheightbatteryinthebatteryholder.Connectthebatterycabletothe3-in-1controlunit.
NOTICE:DonotallowthehelicoptertomoveuntiltheblueLEDonthe3-in-1controlunitissolid.
NOTICE: AlwaysdisconnecttheLi-Pobatteryfromthe3-in-1controlunitoftheaircraftwhennotying.Failure
to do so will render the battery unusable.
Consult local laws and ordinances before choosing a location to fly your aircraft. Selectalarge,openarea
away from people and objects. The Blade mCP X can fly outdoors or indoors in a gymnasium.
CAUTION: PleasetakeafewminutestofamiliarizeyourselfwiththeBlademCPXprimarycontrolsbefore
attemptingyourrstight.TheBlademCPXismoreresponsivethanotherBlademicrohelicopterslikethe
BlademSR.Seekhelpfromanexperiencedpilotifyouarenewtocollectivepitchhelicopters.
Takeo
Graduallyincreasethethrottletoallowthehelicoptertimetoincreaserotorheadspeed.
CAUTION: Donotgiveanyaileron,elevatororruddercommandsbeforetakeofforthehelicoptermaycrash.
Flying
The helicopter lifts off the ground when the rotor head reaches a suitable speed. Establish a low-level hover to
verifyproperoperationofyourhelicopter.Youwillnotneedtosetanytrim;theybarlessdesignofthemCPX
renders trim unnecessary.
For pilots new to collective pitch helicopters, familiarize yourself with your mCP X in normal mode. Discover the
rates that fit your flying style.
CAUTION:Alwaysythehelicopterwithyourbacktothesuntopreventlossofightcontrol.
Landing
Establishalowlevelhover.Slowlylowerthethrottleuntilthehelicopterlands.
Flying the mCP X
Installing the Flight Battery