Blade mQX - Transmitter and Receiver Binding; General Binding Procedure; MLP4 DSM Binding Procedure

6
EN
Transmitter and Receiver Binding
BindingistheprocessofprogrammingthereceiverofthecontrolunittorecognizetheGUID(GloballyUnique
Identier)codeofaspecictransmitter.Youneedto‘bind’yourchosenSpektrum
™
orJR
®
DSM
®

technologyequippedaircrafttransmittertothereceiverforproperoperation.IfyoupurchasedanRTFmodel,
thetransmitterisboundtothemodelatthefactory.
Tobindorre-bindyourmQXtoyourchosentransmitter,pleasefollowthedirectionsbelow.
MLP4DSM Binding Procedure
1.DisconnecttheightbatteryfromtheQuad-Copter.
2.Centeralltrimsonyourtransmitter.Refertothetransmittercontrolsectionfortriminstructions.
3.Poweroffthetransmitterandmovethethrottlesticktothedown/offposition.
4.ConnecttheightbatteryintheQuad-Copter.TheLEDonthe4-in-1Controlunitashesafter5seconds.
5.Pushinandholddowntheleftstickwhilepoweringonthetransmitter(youwillheara‘click’).
6.Releasetheleftstick.ThetransmitterwillbeepandthepowerLEDwillblink.
7.TheQuad-CopterisboundwhentheLEDonthe4-in-1controlunitissolidblue(notblinking).
8.Disconnecttheightbatteryandpowerthetransmitteroff.
General Binding Procedure
1.DisconnecttheightbatteryfromtheQuad-Copter.
2.Selectacleanmodelmemoryonyourtransmitter(computerradiosonly).
3.SelectAcroorAirplanemodeltypeonyourtransmitter
4.MakesureallservoreversingissettoNormalonyourtransmitter
5.Centeralltrimsandmakesuresub-trimsaredisabled(zeroed)onyourtransmitter
6.Poweroffthetransmitterandmoveallswitchestothe0position.Movethethrottletothelow/offposition.
7.ConnecttheightbatteryintheQuad-Copter.TheblueLEDonthe4-in-1controlunitashesafter5
seconds.
8.Putthetransmitterintobindmodewhilepoweringonthetransmitter.
9.Releasethebindbutton/switchafter2–3seconds.TheQuad-CopterisboundwhentheblueLEDonthe
4-in-1controlunitis“on”solid.
10.Disconnecttheightbatteryandpowerthetransmitteroff.
Ifyouencounterproblems,obeybindinginstructionsandrefertothetroubleshootingguideforother
instructions.Ifneeded,contacttheappropriateHorizonProductSupportofce.ForalistofcompatibleDSM
transmitters,pleasevisitwww.bindny.com.
NOTICE:Futabatransmitters(equippedwithSpektrummodules)mayrequireyoutoreversethethrottlechannel.