APPLIANCE DETAILS
ELECTRICAL DETAILS:
OVEN:
Rated Voltage: 220 to 240 Vac 50/60 Hz
Max Rated Inputs: BOSE459X- 2923W
This information can be found on the rating plate (data label) affixed to the inside of the door jamb.
SIZES:
ELECTRICAL CONNECTIONS
LOCAL AUTHORITY REQUIREMENTS
Installation is only permitted by a licensed electrician, and carried out according to instructions
provided by the manufacturer. Incorrect installation might cause harm and damage which the
manufacturer accepts no responsibility.
ELECTRICAL INSTALLATION FOR THE LICENSED ELECTRICIAN
This oven must be connected to a 220-240V 50Hz power supply. It is earthed via the power supply cord. The
earthing cable must be connected via the screw with the earthing mark.
Before carrying out the connection to the power supply, the voltage rating of the appliance (stamped on the
appliance identification plate) must be checked for correspondence to the available mains supply voltage, and
the mains electric wiring should be suitable for the oven’s power rating (also indicated on the appliance
identification plate).
The switched outlet must be connected to a suitable earth wiring, in conformity to current safety regulations.
The cooking appliance must be connected to a switched outlet. It should not be located above the appliance
and no more than 1.25m away from it. The power supply cord must not touch against any hot surfaces and
must be placed so that its temperature does not exceed 75°C at any point along its length.
After having installed the appliance, the switched outlet must always be in an accessible position.
NOTE: For connections to the mains power supply, never use adapters, reductions or multiple power points
as these may overheat and catch fire.
The mains terminal block is located on the back of the oven and the terminals are accessible by opening the
terminal block cover. Note: The terminal cover should not be opened when the mains power is still connected
to the appliance and never by an unauthorized person.
The electrical safety of this appliance can only be guaranteed if the oven is correctly and efficiently earthed.
The manufacturer declines all responsibility for damage resulting from an installation which has not been
earthed correctly.
NOTE: For connections to the mains power supply, never use adapters, reductions or multiple power points
as these may over heat and catch fire. A circuit breaker with a contact opening of at least 3 mm must be
installed inside the circuit supply circuit.
To Next Page
Loading...
Need help?
General
