OPERATING INSTRUCTIONS
Using the Oven
The electronic clock features Touch-Control technology. To operate, simply touch the glass control symbols
with your finger tip.
The touch control sensitivity continuously adapts to ambient conditions. Make sure the glass surface of the
control panel is clean and free of obstacles when plugging in the oven.
If the clock does not respond correctly when you touch the glass, unplug the oven for a few seconds and
then plug it in again. Doing this causes the sensors to adjust automatically so that they will react once more
to the fingertip control.
: Lights up when the clock timer is selected.
AUTO: Lights up to indicate that the oven is programmed.
: Indicates that the oven is transmitting heat to the food.
: Enable you to select a time.
: Enable you to programme the electronic clock functions.
Setting the Time
When you turn on the oven, you will see the clock flashing 12:00.
Set the clock by touching the + or – sensor.
You will hear 2 beeps confirming that the time has been set.
To change the time, press the + and the – sensors at the same time. The current time will then flash on the
screen. Change the time by pressing the + or – sensors. Two beeps will then confirm that the new time has
been set.
Note
The clock light has a night mode so the display will dim between 00:00 and 06:00 hours.
Manual Operation
After setting the clock, the oven is ready for use. Select a cooking function and temperature.
During cooking, the symbol for heat being transmitted to food will light up to indicate that heat is being
transmitted.
This symbol turns itself off when the selected temperature has been reached.
Set the controls to to turn off the oven.
Caution
After cooking, you will notice that the oven cooling system is still on. This is normal and is used to cool the
oven down quickly.
Electronic Clock Settings
Timer Alarm: The alarm will go off at the programmed time, even if the oven has finished cooking.
Cooking Time: This function allows you to programme the cooking time, after which the oven will turn off
automatically.
To Next Page
Loading...
Need help?
General
