DOOR LOCK
This is a safety feature which can be used to stop children from opening the door while the oven is in
operation. The door must be left closed while the door lock is activating or deactivating. To manually
activate or deactivate the door lock (not while the pyrolysis function is active), press and hold the
Adjustment control knob in for six seconds. The Door Lock indicator will start to flash and the door latch will
start to move internally. When the door lock is fully in position, the Door Lock indicator will stop flashing (if it
stays on, the door lock is active, if off, the door lock is inactive). This does not require an oven function to
be on to be used, and does not affect any other function.
SETTING TIME OF DAY
When the power is first connected, the display will flash the default time (12:00). To adjust the time, first
rotate the Function control knob to Off (0). If the display is not already flashing, rotate the Adjustment
control knob either left or right so the display flashes. rotate the Adjustment control knob again so that only
the hours are flashing, and then adjust by rotating the Adjustment control knob left or right. Leave for 5
seconds until the minutes start to flash, and adjust in the same way. Leave for 5 seconds and the whole
display will flash for 10 seconds and then stop, locking in the new time.
SETTING ALARM VOLUME
Adjust the Oven Function control knob to the Light function. Rotate the Adjustment control knob to adjust
the alarm volume (cycle through 3 different volumes). Note: The alarm sounds only work between 8.00 &
22.00.
MANUAL COOKING
To use the oven without any timer functions, first start by adjusting the Function control knob to the desired
oven cooking function. The display will briefly show “on”. Light and Defrost Conventional Fan will start up
automatically. For the other cooking functions, the default temperature will be shown (the temperature
indicator will also be lit). If this is acceptable, no changes need to be made. If a different temperature is
desired, rotate the Adjustment control knob left (reduce) or right (increase) until the desired temperature is
reached. While the internal temperature is increasing, the Pre-heat indicator will flash. Once the correct
temperature is reached, the Pre-heat indicator will stop flashing and a short sequence of 3 beeps x 5 will
sound, indicating that the preheat process has finished. The food can now be placed in the oven. The oven
will continue to cook (a maximum of 12 hours) until the Function control knob is rotated to off (0). When a
function is chosen that uses a cooking element (not the Light and Defrost Conventional Fan functions) the
Cooking Function indicator will light up. This will turn off when the oven has finished cooking.
MINUTE MINDER
The Minute Minder is a timer set to run for a certain time (pre-set 30 minutes, max 240 minutes) and then
sound an alarm. The Minute Minder has no effect on any oven function.
Press the Adjustment control knob until the Minute Minder indicator turns on (displaying the current Minute
Minder setting). Rotate the Adjustment control knob to either side so that the current Minute Minder time is
flashing. Adjust this time by rotating the Adjustment control knob left (reduce) or right (increase) until the
desired time is displayed. Four seconds after the last adjustment, the current Minute Minder time will stop
flashing (time has been set), and the Minute Minder will start to count down. The display can be adjusted
now to another timer function or to show the current time.
Once the Minute Minder has finished, an alarm will sound (a double beep every 3 seconds) and the Minute
Minder indicator will flash. Rotate the Adjustment control knob to either side, and the alarm will turn off. The
Minute Minder indicator will turn off.
To Next Page
Loading...
Need help?
General
