16
- Turn the selector left/right, the hours
flash.
- Modify the flashing hours value turning the selector left/right.
- Push the Temp & Time selector to switch back and forth between hours and minutes.
- Modify the flashing minutes turning left/right.
- After a few seconds the whole time of day value starts flashing: wait until the new time
of day is steady.
Fig. 9a
Push the knob to toggle between the time of day and the minute minder and check the set
values. The clock is selected by default while the symbol appears when the minute minder is
displayed.
Setting the minute
minder
When the symbol is displayed, turn the knob left/right in order to set the timer value. The
standard value is 30 minutes, it’s possible to modify it in the range between 0 and 240
minutes.
This timer has no influence on the oven activities and can be set also when the oven is off.
The time of day is displayed with priority in any case, the symbol shows the minute minder is
active.
When the time expires, the symbol flashes and the buzzer sounds a warning sequence (two
short beeps repeated every 3 seconds) to recall the user attention. Push the knob to stop it.
The buzzer stops in any case after a time
out.
Setting an oven
function
man
uall
y
Turn the mode knob into the desired position, the clock display shows On for a few seconds. The
oven will work for a maximum time (12hours). In this oven there are 10 different functions.
If the selected function works using any heating elements, the symbol is displayed (it doesn’t
To Next Page
Loading...
Need help?
General
