6
Installation of your oven
To install the oven into the kitchen a cutout should be made in accordance with the dimensions
shown below. Please allow for 3/ 4mm of a difference in the dimensions provided below. Please
measure the original product to ensure that the cut out details are correct.
The apparatus is to be fastened to the top by means of the two screws provided in the kit through
the holes made on the oven uprights.
The cabinet in which the apparatus is installed shall be open on the back side to ensure a
sufficient air circulation and prevent overheating.
Leave a gap of at least 200 cm2 (see Fig. 1) for air circulation if the oven is installed in a column;
this is not necessary if the oven is installed under the work top.
W
ARNING
As the
apparatus
is to be
fitted
in your
kitchen furniture, make
sure that
all
surfaces
in
contact
with the oven can resist a
temperature
of approx
90°C.
To Next Page
Loading...
Need help?
General
