636
Troubleshooting
Too little sparkling
content
1 • Adjust temperature setting: the colder the water, the more
effectively CO
2
can be added to the water
2 • Leave system to cool down (about 12 hours)
• Dispense 2 x 0.3 liters of sparkling water
• Wait another hour and re-evaluate
3 • Run cleaning program
Water temperature is not
the set temperature
• Leave system to cool down and heat through (about 12 hours) and
re-evaluate
Sparkling water spray
pattern not OK or too
weak
1 • Replace CO
2
cylinder
2 • Open jet aerator on the mixer tap with enclosed
spanner and clean
3 • Check correct installation (corner valves fully open, filter
and CO
2
cylinder fully screwed in, supply hose kinked?)
Mixer tap dripping 1 • Re-calibrate system (see page 56)
Not possible to dispense
sparkling water (weak
still water flow although
'sparkling' is set on
mixer tap)
1 • Check CO
2
cylinder is fitted properly (cylinder has been
inserted correctly if you hear a hissing sound when cylinder
is unscrewed)
• Screw in CO
2
cylinder firmly and tighten another 1/4 turn
2
• Replace with original BLANCO CO
2
cylinder only
BLANCO CO
2
cylinders may be used.
Dispensing quantities of
the refined water types
are not correct
• Re-calibrate system (see page 56)
• Check the routing of the blue and red plastic tubes (cool and hot water
tubes) and the flexible hoses and look out for kinks.
Dispensing quantities of
hot water are not correct
• Check the routing of the red plastic tube (hot water tube) and the flexible
hoses and look out for kinks.
CO
2
bottle freezes over
during the cleaning
program
• Filter was not inserted correctly
• Allow the cleaning program to continue running
• Insert filter correctly and carry out cleaning again with filter inserted
To Next Page
Loading...
