BB+13
Declaration of conformity (DOC)
Model number: BB+13
Trade name: Blaupunkt
Responsible party: M3 Electronic GmbH Gutenbergstrasse 5, D-65830 Kriftel. Germany
Hereby, Blaupunkt Competence Center Audio M3 Electronic GmbH, declares that this Class 1 equipment is in compliance
with the essential requirement and other relevant provisions of Directive 1999/5/EC.
Letter of conformity can be obtained from info@m3-electronic.de.
Safety Instructions
1. READ INSTRUCTIONS – All the safety and operating instructions should be read before
appliance's operated.
2. RETAIN INSTRUCTIONS - The safety and operating instructions should be retained for
future reference.
3. HEED WARNINGS – All warnings on the appliance and in the operating instructions should
be adhered to.
4. FOLLOW INSTRUCTIONS – All operating instructions should be followed.
5. WATER AND MOISTURE – The appliance should not be used near water, for example, near a
bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in web basement.
6. VENTILATION – The appliance should be situated so that its location or position does not
interfere with its proper ventilation. Do not place on bed, sofa, rug or similar surface that may
block the ventilation openings, in a built-in installation, such as a bookcase or cabinet that
may impede the flow of air through the ventilation openings.
7. HEAT – The appliance should be situated away from heat sources such as radiators, stoves,
or other appliances (including amplifiers) that produce heat.
8. POWER SOURCE – the appliance should be connected to power supply only of the type
described in the operating instructions or as marked on the appliance.
9. POWER CORD PROTECTION – power supply cords should be routed so that they are not
likely to be walked on or pinched by items placed upon or against them.
10. POWER LINES – an outdoor antenna should be located away from power lines.
11. OBJECT AND LIQUID ENTRY – care should be taken so that objects do not fall and liquids
are not spilled into the enclosure through openings.
12. ESD WARNING – the display does not function properly or not reaction to operation of any
the control may due to the electrostatic discharge. Switch off and unplug the set. Reconnect
after a few seconds.
13. DAMAGE REQUIRING SERVICE – the appliance should be serviced by qualified service
personal when: a. the power-supply cord or plug has been damaged. b. Objects have fallen
into, or liquid has been spilled into the appliance enclosure. c. The appliance has been
exposed to rain. d. The appliance has been dropped, or the enclosure damaged. e. The
appliance does not appear to operate normally.
41
To Next Page
Loading...
Need help?
General
