BB+13
DAB SCANNING
RE-SCANNING FOR DAB STATIONS
When first used, your radio scanned the DAB band for available stations. The station services
found were then stored in your system's memory.
You can re-scan the band at any time if you move to a different area or just to refresh the stored
list of available stations.
To scan for DAB stations manually:
Select the DAB band.
Press the SCAN button on the front panel.
The scanning process will take a few minutes. The number of services found during the scan
will be shown at the right side of the display.
After the scan, the radio will re-tune to the first station in the station list to play if it is available.
To select this station, you can continue to browse for another station as described on the
previous page.
DAB DISPLAY MODES
DISPLAY MODE OPTIONS
The bottom line of the display can be switched to show different items of information that may
be transmitted with a DAB station.
Choosing the information display:
Press the INFO. button on the front panel repeatedly to change the information displayed
while playing a DAB radio station.
The full range of display options are shown below. Some stations may not broadcast all of
these options.
·
·
46
To Next Page
Loading...
Need help?
General
