Blaupunkt Colorado CM 168 - Radio Operation; Selecting a Waveband; Station Tuning; Automatic Seek Tuning A;V

Radio operation
Selecting a waveband
With this car radio you can select between
the following wavebands:
FM 87.5 - 107.9 MHz
AM 530- 1710 kHz
l Select the desired waveband by
pressing the BNTS button.
Station tuning
Automatic seek tuning A/V
l
Press A or V; the car radio will auto-
matically search for the next station.
If you hold A/v pressed up or down on the
rocker switch, seek tuning will speed up in
the upwards or downwards direction.
Automatic seek tuning
A UP
V Down
Manual tuning with C-Z >>
You can also tune into a station manually.
l
Press << >>; the frequency will
.
change in short intervals in the down-
wards or upwards direction.
If you hold CC >> pressed to the left or the
right on the rocker switch, the frequency
scan will speed up.
Switching between the memory
banks (FM)
You can switch between the memory banks
FMl, FM2 and FMT in order to store sta-
tions and recall them later.
The currently selected memory bank ap-
pears in the display.
l Press the BNTS button as many
times as necessary until the desired
memory bank lights up in the display.
Storing stations
On FM, you can store six stations on the
preset buttons 1, 2, 3, 4, 5, 6 for each of
the memory banks (FMl, FM2, FMT).
You can also store six stations on AM.
l
Select the waveband by pressing
BAITS.
l
Tune into a station with the rocker
switch (either automatically A/V or
manually << >>).
l
Press the desired preset button until
the radio resumes play after the mut-
ing (takes approximately 2 seconds)
or until you hear a beep.
Now the station has been stored.
The display will temporarily indicate which
, preset button is currently activated.
Recalling stored stations
You can recall any stored station at the
touch of a button.
l Select the waveband by pressing
BAITS. For FM, also choose the cor-
responding memory bank by pressing
the BMS button as many times as
necessary until the desired bank ap-
pears in the display.
l Press the corresponding preset button
briefly to recall the station.
Scanning stations with
Preset Scan
You can scan all of the radio stations on
AM or FM.
The scanned stations of the current wave-
band will appear briefly one after the other
in the display.
Start Preset Scan:
l Press PS briefly.
“PS-Scan” and the station name or frequen-
cy will appear alternately in the display.
11