Blaupunkt Colorado CM 168 - Deleting Radio Station Names; Deleting a Radio Station Name; Deleting All of the Radio Station Names; Setting the TIMER

l Now you are in the edit mode. If the
station selected does not have a
name, 8 dashes “_” will appear in the
display.
l The cursor will flash at the current po-
sition. Press cc >> to move the cur-
sor.
l
Press A/V to select the station you
would like to delete.
l
Press and hold down DSC.
“ONE NAME” will appear in the dis-
play.
l Press A/V to select a character. If
you want to enter a blank, select the
dash “_“.
l Press DSC to store the name. Press
DSC again to quit the DSC mode or
press c< z=> to re-enter the station-se-
lect mode.
l
Release the DSC button after 2 sec-
onds but before 8 seconds. “DELET-
ED” will appear in the display.
l
The station name has been deleted.
The unit will switch back to DSC
mode.
Deleting all of the radio station names
Select the DSC mode.
Press DSC.
If you want to change the name, select the
name in the DSC mode and overwrite it in
.
the edit mode. If you want to change just a
l
few of the letters, press c< >> to move the
l
cursor to the corresponding position and
change only that character.
.
Deleting radio station names
.
Deleting a radio station name
Select the DSC mode.
l Press DSC.
.
l Press A/V to select STA-NAME.
l Press <c >r to switch to the station
select mode.
Press NV to select STA-NAME.
Press c< >> to switch to the station
select mode.
Press and hold down DSC for 8 sec-
onds.
After 2 seconds and 8 seconds you
will hear a beep. “ONE NAME” will ap-
pear first in the display, followed by
“ALLNAMES”
Release DSC. “DELETED” will appear
in the display. All of the station names
have been deleted. The unit will
switch back to DSC mode.
Setting the TIMER
Using this unit it is possible to conveniently
switch on any two radio stations you select
at any time you select. The radio stations
can be selected independently of the cur-
rently active operating mode.
Proceed as follows:
Select the radio station of your choice.
Press DSC.
Press A/v to select TIMER 1.
Press >> to turn the TIMER on. (Press
cc to turn the TIMER off.).
Press >> again to select time display.
The minutes will flash.
Press A/V to set the minutes.
Press << to activate the hour. (>>
back to the minutes).
Press A/V to set the hour.
Press DSC to store your entry. You
have now set TIMER 1.
If you would like to set TIMER 2 as well,
repeat the steps as described above.
Note
The timers can be turned on and off while
any audio source is in use.
13