Deleting all CD names
All of the CD names stored in the CD chang-
er will be deleted.
Select DSC programming mode.
l Press DSC.
l Press
h/v
to select
CDC_NAME.
l Press c<
>>
to enter the CD select
mode.
l Press DSC and hold it down. After 2
seconds and after 8 seconds you will
hear a beep respectively
“ONE-NAME” and then “ALLNAMES”
will appear in the display.
l Release DSC. “DELETED” will appear
in the display. The names of all of the
CDs have now been deleted. The
main CDC_NAME menu will appear
again in the display.
,
Clock/Display changes
This unit is equipped with an internal clock.
DiSDhV
DriOrity:
To alter the display priority, press
0
until
you hear a beep. Repeat this procedure
until the desired display appears.
Temoorarv
DiSDlaV
chanaes
Press
0
briefly as many times as needed
to show the desired information for a few
seconds.
Setting the clock
Set the clock in the DSC mode.
Press DSC briefly.
Press
A/V
to select the function
“CLOCKSET”.
Press
<<
>>
to activate the hours or
the minutes. The option you can set
will flash.
Press
A/V
to alter the flashing dis-
play.
When you have completed the setting,
press DSC briefly to store it.
Press DSC again to exit DSC mode.
Naming an external audio
source
AUX NAME makes it possible to enter a
name of up to 8 characters for an external
audio source (AUX ON, see DSC Menu).
For this, press SRC to select the AUX mode
(only possible if AUX ON is set in the DSC
menu and a CD changer is not connected).
l Press SRC as often as required until
AUX appears in the display.
Enter the AUX NAME in the DSC menu.
l Press DSC briefly.
l Press
A/V
to select the AUX NAME
function
l Press c<
>>
to enter into editing
mode.
The adjustable position will flash.
Press
A/V
to change the flashing po-
sition. Select a dash
“_‘I
to leave a
blank space.
Press c<
>>
to select the next posi-
tion.
When you have entered the name
completely, press DSC briefly to store
the name.
Press DSC again to quit the DSC
menu.
18
To Next Page
Loading...
