Press the button indicating the oppo-
site direction,
Qb
or
A/V
to stop tape
winding.
Chanaer mode (optional)
Select CD
A
UP
V
Down
Select track
>>
Up: press briefly
CUE
-
fast forward (audible):
hold button down.
c<
Down: press two or more
times briefly
Repeat track: press once
briefly.
REVIEW
-
fast reverse
(audible)
-
hold button
down.
Additional rocker switch functions:
For additional settings use
AUD
11
8
DSC-MODE 4
Important: The corresponding func-
,
tion must be active.
@
SRC (Source)
Press button briefly to select the oper-
ating mode (tuner, cassette, changer
or Aux-in). The active mode will ap-
pear in the display.
0
11
AUD
Treble and bass adjustment
You can store different settings for the
FM, AM, cassette, CD-changer mode
or Aux-in.
Setting the tone:
l Select the operating mode.
Press AUD once and use the rocker
switch to set the tone.
A
Treble +
V
Treble
-
<<
Bass
-
>>
Bass +
For Fader and balance adjustment:
press AUD twice.
A
Fader front
V
Fader rear
<<
Balance left
>>
Balance right
The selected values will appear in the
display. The last setting is stored au-
tomatically.
Switching AUD off: Press the button
again briefly.
If you do not make any adjustments to
the tone within 8 seconds, the AUD
mode will quit automatically.
@
LD: Loudness
Loudness boosts the bass frequency
at low volume.
Loudness on/off: Press LD briefly.
“LD” will appear when this setting is
active.
Refer to the section on DSC program-
ming to adjust Loudness to different
levels.
@
(
I)
DIS - Clock display
This unit is equipped with an internal
clock.
Display priority
To alter the display priority, press
0
until you hear a beep. Repeat this pro-
cedure until the desired display ap-
pears.
Temporarv displav change
Press !9 briefly as many times as
needed to show the desired informa-
tion for a few seconds.
Radio mode
Press this button to switch between
the clock, the station name and the
frequency.
6
To Next Page
Loading...
