Blaupunkt Hamburg MP68 - Selecting 12 H;24 H Time Display (Clk MODE); Setting the Time (Clk SET); Changing Volume Presettings; Adjusting Power-On Volume (on Vol;Last VOL)

User settings
.... Switch between the settings with the
rocker switch < or > @.
- > "OFF ClK"@": Time display is on.
- < "OFF ClK" 0: Time display is off.
.... Press the OK button 0 to select a dif-
ferent function, or press the DIS-ESC
button @to exit the menu.
Selecting 12h/24h time display
(ClKMODE)
The time can be displayed using the 12-hour
or 24-hour format.
.... In the System menu, press the rocker
switch A or v @ repeatedly until the
"ClK MODE" menu item is selected.
.... Press the OK button 0to call up the
menu item .
....
Use the rocker switch A or v @ to se-
lect the setting "12 HR AM", "12 HR PM"
or "24 HR MODE".
.... Press the> rocker switch @ to switch
on the selected setting.
.... Press the OK button 0 to select a dif-
ferent function, or press the DIS/ESC
button @toexitthe menu.
Setting the time (ClK SET)
.... In the System menu, press the rocker
switch A or v @ repeatedly until the
"ClK SET" menu item is selected.
.... Press the OK button 0 to call up the
menu item.
The time is displayed.
.... Select the hours or minutes with the
rocker switch < or> @.
54
.... Enter the desired digit by pressing the
corresponding button of the keys 0.
After entering the complete time,
.... press the OK button 0 to store the
time entered .
Note:
To finish the entry without changing the
time, press the DIS-ESC button @.
Changing volume presettings
The following presettings can be changed in
the System menu:
• Power-on volume (ON VOL)
• Volume presettings of telephone/nav-
igation announcement (TEL VOL) and
volume reduction (MUTE VOL)
• Signal tone (BEEP ON)
• Speed-dependent volume increase
(AUTO SND)
Adjusting power-on volume (ON VOLI
lAST VOL)
To adjust the power-on volume,
.... in the System menu, press the rocker
switch A or v @ repeatedly until the
"ON VOL" menu item is selected .
....
Press the OK button 0to call up the
menu item.
The current power-on volume is displayed .
....
Set the power-on volume with the rock-
er switch < or > @.
.... Press the OK button 0 to select a dif-
ferent function, or press the DIS-ESC
button @ to exit the menu.