Blaupunkt Hamburg MP68 - Changing Volume Presettings for TEL and MUTE; Activating;Deactivating the Signal Tone (BEEP ON)

Alternately, you can select the "lAST VOl"
setting. This sets the volume at power-on to
the volume at the last switch-off:
.... In the System menu, press the rocker
switch /\ or Y @ repeatedly until the
IlASTVOl" menu item is selected.
.... Press the OK button ® to call up the
menu item.
.... Switch between the settings with the
rocker switch < or > @.
- >llASTVOl"@":On.
- <
"lAST VOl" 0: Off.
.... Press the OK button ® to select a dif-
ferent function. or press the DIS-ESC
button ® to exit the menu.
Note:
If "lAST VOl" is selected, the device is
switched on with the volume adjusted
under liON VOl".
Changing volume presettings for TEL
and MUTE
If the device switches a phone call or navi-
gation announcement, it is always done with
the volume preset here.
In addition, you can assign a lower volume
up to the value 0 (mute) to the volume re-
duction (MUTE).
.... In the System menu, press the rock-
er switch /\ or v @ repeatedly until of
these menu items is displayed:
- "MUTE VOl": Presetting the volume
of the volume reduction
User settings
- "TEl VOl": Presetting the volume of
the phone call/navigation announce-
ment
.... Press the OK button ® to call up the
menu item.
The currently set volume is displayed .
....
Set the volume with the rocker switch
<or>@ .
....
Press the OK button ® to select a dif-
ferent function, or press the DIS-ESC
button ® to exit the menu.
Notes:
The volume preset by you will not be
used,
- if the volume currently listened to is
lower than the set mute level. The de-
vice continues playing with the vol-
ume listened to.
- if the volume currently listened to is
higher than the set TEL volume. In
this case, phone calls/navigation an-
nouncements are reproduced with
the volume listened to.
Activating/deactivating the signal tone
(BEEP ON)
You can deactivate the signal tone that
sounds as a confirmation in the menus or
when storing the stations on the station but-
tons.
.... In the System menu, press the rocker
switch /\ or V @ repeatedly until the
"BEEP ON" menu item is selected.
.... Press the OK button ® to call up the
menu item.
55