General functions
76
Connect the USB medium to
the USB cable that is routed
from the rear side of the de-
vice.
The USB medium can now be
selected as audio source.
For the device to recognise the
USB medium, it must be specifi ed
as mass storage device and for-
matted using the FAT16 or FAT32
fi le system and contain MP3 or
WMA fi les. Blaupunkt cannot
guarantee the proper function-
ing of all USB media available on
the market. If extensive fi les are
stored on your USB 2.0 medium,
the fi le search (see page 100) can
be slow.
Adjusting the volume
WARNING!
Danger from excessive
volume!
Excessive volume can damage
your hearing and you may fail to
hear acoustic warning signals!
Do not change the volume
while the device changes the
CD in the CD changer or the
audio source.
Always set the device to a mod-
erate volume.
➔
➔
➔
Turn the volume control
5.
The current volume is shown
on the display and used for all
audio sources.
Note:
To preset the volume of traffi c
announcements (Traf), a con-
nected telephone (Phone) and
the signal tone (Beep), see
page 115 and 116.
Muting the device
The device can be muted as fol-
lows:
Briefl y press the On/Off but-
ton
4.
The display shows "MUTE".
To cancel the mute function:
Briefl y press the On/Off but-
ton
4 again or turn the volume
control
5.
Operation with telephone
If a hands-free system is installed
in your vehicle or your cell phone
is connected to the device via a
Bluetooth adapter, the device re-
sponds as follows to incoming or
outgoing telephone calls:
If the device is switched off, it
automatically switches on if a
call is received or made.
➔
➔
➔
•
02_BA_Memphis_EU_eng.indd AllgFkt7602_BA_Memphis_EU_eng.indd AllgFkt76 03.05.2006 10:44:01 Uhr03.05.2006 10:44:01 Uhr
To Next Page
Loading...
Need help?
General
Weight and Dimensions
