Error table
122
On the rocker switch 3,
repeatedly press
or to
increase the scan time.
On the rocker switch 3,
repeatedly press
or to
decrease the scan time.
You can adjust scan times in in-
crements of 5 seconds form 5 to
30 seconds.
➔
➔
Displaying the serial number
( Serial Number)
Every device has a separate serial
number. To display this number:
Press the softkey
: (next to
"Serial Number").
The serial number is displayed.
➔
Error table
If the device does not function properly, switch the device off and on
again.
If problems still persist, you can easily correct the following problems.
Problem Possible cause Possible remedy
The menus do not appear
as shown in these instruc-
tions.
The tuner cannot be adjust-
ed to the frequencies listed
in the technical data.
The device is not set to
your region.
Set the device to your
region as described on
page 88.
The display shows informa-
tion about the device.
The demo mode is acti-
vated.
Press and hold the MENU
button
? for four seconds.
The device is always silent,
even though it is correctly
connected.
The internal amplifi er is
switched off.
Switch on the internal
amplifi er as described on
page 121.
If problems still persist, please contact an authorised workshop or the
Blaupunkt customer service (see the last page).
02_BA_Memphis_EU_eng.indd Fehler12202_BA_Memphis_EU_eng.indd Fehler122 03.05.2006 10:44:13 Uhr03.05.2006 10:44:13 Uhr
To Next Page
Loading...
Need help?
General
Weight and Dimensions
