Blaupunkt MEMPHIS MP66 - Changing the Volume Presetting of the Signal Tone (Beep Volume); Changing the Presetting of the Power-On Volume (on Volume); Restoring the Volume at Switch-On (Last Volume)

Changing basic settings in the settings menu
116
The volume presetting for
phone calls appears.
Adjust the desired volume us-
ing the volume control
5 or
the rocker switch
3 (incre-
ments 1 to 50).
During the phone call, you can
always change the volume by
means of the volume control
5.
Changing the volume presetting
of the signal tone ( Beep Volume)
If a signal tone sounds, you al-
ways hear it at the preset volume.
Press the softkey
9 (next to
"Beep Volume").
The volume presetting for the
signal tone appears.
Adjust the desired volume
using the volume control
5
or the rocker switch
3 (incre-
ments 0 to 6).
You hear a signal tone at the se-
lected volume.
If you do not want to hear any
signal tones, set the volume to
zero.
"BEEP OFF" appears on the dis-
play.
Changing the presetting of the
power-on volume ( On Volume)
You can confi gure the device so
that the playback after switch-
on always starts with the volume
set here. For this purpose, the
➔
➔
➔
➔
"On Volume" menu item must be
highlighted.
Press the softkey
< (next to
"On Volume").
The presetting for the power-
on volume appears.
Adjust the desired volume
using the volume control
5
or the rocker switch
3 (incre-
ments 1 to 50).
If you open the "Volume Set-
tings" menu again, the "On Vol-
ume" menu item is highlighted.
Restoring the volume at switch-
on ( Last Volume)
You can confi gure the device so
that the playback after switch-on
always starts with the previously
selected volume. For this pur-
pose, the "Last Volume" menu
item must be highlighted.
Press the softkey
; (next to
"Last Volume").
"Last Volume active" briefl y
appears on the display. If you
open the "Volume Settings"
menu again, the "Last Volume"
menu item is highlighted.
➔
➔
➔
02_BA_Memphis_EU_eng.indd Menü11602_BA_Memphis_EU_eng.indd Menü116 03.05.2006 10:44:11 Uhr03.05.2006 10:44:11 Uhr