59
DANSK
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Selecting the waveband /
memory bank
This device can receive programmes
broadcast over the FM, MW and LW
(AM) wavebands.
There are four memory banks for the
FM range and one for each of the MW
and LW ranges.
Six stations can be stored in each mem-
ory bank.
Note:
If your device is configured for the USA
region, you can choose between the FM
and AM wavebands.
There are three additional memory
banks available for the AM waveband:
AM1, AM2 and AMT.
Selecting the waveband
To select the FM, MW or LW waveband,
➮ press the TUNER button = while
in radio mode.
The radio functions menu appears in the
display.
➮ Press the softkey 5 assigned to
the “BAND” display item.
➮ Press the softkey 5 assigned to
the “FM” display item for the FM
waveband.
➮ Press the softkey 5 assigned to
the “MW” display item for the MW
waveband.
➮ Press the softkey 5 assigned to
the “LW” display item for the LW
waveband.
The main radio menu for the selected
waveband is displayed.
Selecting an FM memory bank
To switch between the FM memory
banks FM1, FM2, FM3 and FMT,
➮ press the NEXT button 4 repeat-
edly until the memory bank that
you want is displayed.
The memory banks are accessed in the
following order: FM1, FM2, FM3 and
FMT.
Note:
If your device is configured for the USA
region and you selected the AM wave-
band, you can additionally switch be-
tween the AM memory banks (AM1,
AM2 and AMT) by pressing the NEXT
4 button.
Tuning into a station
There are various ways of tuning into a
station.
Automatic station seek tuning
➮ Move the joystick 8 down or up.
The radio tunes into the next receiva-
ble station.
Tuning into stations manually
You can also tune into stations manual-
ly.
Note:
You can only tune into stations manual-
ly if the RDS function is deactivated.
➮ Move the joystick 8 left or right.
RADIO MODE
To Next Page
Loading...
Need help?
General
