16
➜ Carefully push the guide of the
Lucca over the track of the suction
cup holder.
Installing Lucca in the Cradle
The cradle features a track for mount-
ing the Lucca on the inside.
➜ Carefully push the guide of the
Lucca over the track of the suction
cup holder.
Removing the Lucca
➜ Pull the Lucca up and out of the
cradle or the support. If neces-
sary, securely support the cradle
or the support.
Switching on/off
Switch-on
➜ To switch on the Lucca, push the
button
below the display.
The device switches on and dis-
plays the previously active display
(menu, destination guidance).
Activating the Idle State
➜ To activate the idle state, briefl y
push the button below the dis-
play.
The Lucca switches to the idle
state.
Switch-off
➜ To switch off the device, press and
hold the button
for longer than
4 seconds.
The Lucca is switched off.
Note:
A complete switch-off of the Lucca
is only necessary if you do not op-
erate the device for an extended
period of time or if you want to
load new map material from the
memory card.
Reactivating
➜ In this state, the power-on button
must be pressed for longer than
4 seconds to switch on the Lucca.
Switching on/off
Lucca_long_2G_eng.indd 16Lucca_long_2G_eng.indd 16 13.04.2006 11:53:36 Uhr13.04.2006 11:53:36 Uhr
To Next Page
Loading...