11
PULSE
The Pulse function is used for chopping, mincing, whipping, or other momentary
tasks that do not require a long blend cycle� You can also Pulse
to quickly stir a
blend before serving�
The Pulse setting runs at speed 7 and will only run while the Pulse
icon remains
pressed� When the icon is released, the motor shuts off�
SECTION 6: CARE AND CLEANING
6.1 CLEANING AFTER USE
1� Add 1 cup (240ml) of hot water and a drop of liquid dish washing soap to the blender jar�
2� Place the lid tightly onto the jar�
3� Place the blender jar on the blender base and, with your hand placed on top of the
lid, the Pulse button for 5 seconds or press the Clean cycle button which is available
on select models�
4� Rinse well�
5� Clean the blender base by simply wiping the base and interface with a damp cloth�
6.2 LONG-TERM SANITATION
1� For long-term sanitation, fill the blender jar with hot water�
2� Add one to two teaspoons (5-10ml) of liquid chlorine bleach to the jar�
3� Stir for 10 seconds to mix water and bleach� Let mixture stand in blender jar for
five minutes�
4� Empty water/bleach mixture� Turn jar upside down on dish rack until dry�
6.3 CLEANING TIPS AND CAUTIONS
1� Do not use stiff bristled brushes or abrasive cloths/pads to clean the blender base or
jar, as this will dull or scratch the surface�
2� NEVER submerge the blender motor in water� Avoid submerging blender jars for more
than 5 minutes� Water penetration through the lower jar seals will reduce the life of the
jar� After cleaning, we recommend the blender jar be stored upright�
3� BLENDER JAR IS DISHWASHER SAFE—TOP RACK ONLY!
4� Extreme temperatures damage the lower seal of the jar� We recommend hand
washing to prolong the life of the blender jar� We do not recommend the jar be used
or exposed to, temperatures above boiling (212°F, 100°C)�
To Next Page
Loading...
