10
▶
If you are not using your jar daily, before each use, reach under the bottom of the jar
and turn the drive shaft for a few seconds� This will help keep the seal in good shape
and prolong the life of the jar� If the shaft does not spin easily, add some hot water to
the jar, then twist the shaft by hand until it begins to spin freely�
▶
Do not place jar onto motor base while the motor is running as this causes the jar
drive shaft to wear prematurely� Shaking or rocking the jar while on the motor base
will also cause premature wear�
▶
Abrasive cleaners or sponges are not recommended as they will dull or scratch the
surfaces of the jar�
▶
To maintain the best seal between the lid and jar, do not store jar with lid in place�
▶
If blending grains, the interior of the jar will fog� This is from grain bursting and will not
affect the integrity of the jar�
▶
Spices and coffee can permanently discolor the jar and flavors may be impregnated
into the jar� We recommend having a second jar for this purpose�
SECTION 6 - OPERATIONAL OVERVIEW
Your blender has 25 pre-programmed blend cycles for your convenience, as well as
optional manual controls� A representation of the touchpad controls is found below�
6.1 BEFORE YOU BEGIN OPERATION
1� Turn on the main power switch located on the back of the blender motor base�
2� Place ingredients in jar�
3� Attach the blender jar lid�
4� Place the blender jar on the base, making sure the jar is secure�
6.2 MANUAL CONTROLS
The “START/STOP” button can be pressed at any time to stop the current blender
function�
The “PULSE” button is used when you want to chop, mince, whip, or do other
momentary tasks which do not require a long blend cycle� When the “PULSE” button
is pushed the motor will run only as long as the button is held down� As soon as the
button is released the motor will shut off� The pulse function can also be activated
To Next Page
Loading...
