11
during a blend cycle� When the “PULSE” button is pressed the current cycle pauses and
the pulse begins� When the “PULSE” button is released, the selected cycle resumes�
Pressing the “SPEED UP” button will start a speed cycle for 50 seconds� During this
time press or hold down the “SPEED UP” or “SPEED DOWN” arrows to control up to 10
speeds at which the blender can operate� Simply press the “SPEED UP” button and the
motor will begin� Continue pressing the “SPEED UP” key to increase the speed, or press
the “SPEED DOWN” key at any time to decrease speed� After you have reached the
desired speed release the button�
6.3 AUTOMATIC AND CUSTOM CONTROL PRESETS
BUTTONS – 1, 2, 3, 4: The four numbered buttons on the left side of the touchpad
operate four customizable pre-selected blend cycles� To select one of these presets,
simply press the designated button� The buttons are set at the factory to the following
blend cycles:
Button 1 �����“Slow” cycle
Button 2 �����“Smoothie” cycle
Button 3 �����“Mixed Drinks” cycle
Button 4 �����“Whole Juice” cycle
SELECTING A BLEND CYCLE FROM THE CYCLE MENU: To access the Cycle Menu,
press the “CYCLE MENU” button� The first category to appear on the LCD display is
BEVERAGES� Continue pressing or hold down the “CYCLE MENU” button to scroll
through the cycle categories� (Figure 3 is a chart showing the blend cycle within each
category�)
Once the desired blend cycle category has been reached, press or hold down the
arrow keys to scroll through the blend cycles listed in that category� When you find a
blend cycle you want to use, press the “START/STOP” button� The LCD display will show
the cycle name and the time remaining will be displayed while the cycle is running�
PROGRAMMING A PRESET BUTTON (Button 1-4): For blend cycles you use frequently,
there are 4 preset buttons on the touchpad numbered 1, 2, 3, and 4, which you can
use to save any of the pre-programmed blend cycles� This will allow you to simply press
button 1, 2, 3, or 4, when you want to use that specific blend cycle�
Enter the Menu Mode by pressing the “CYCLE MENU” button� Using the “CYCLE
MENU” and “UP/DOWN” arrows, navigate to the cycle you wish to program onto the
preset� When the desired blend cycle appears on the LCD display, press and hold the
desired preset button (Button 1, 2, 3 or 4) for two seconds�
The display will first show the name of the existing cycle, and then the display will
read - “ProgrammingBttnX”, where “X” is the number of the preset button� When the
programming is complete, the display will read “Program Complete”� The blender will
exit the Menu Mode automatically, and the preset button is now available for use� The
next time you choose that button, it will run the blend cycle which you have saved to it�
If the blender fails to program the preset button, the display will read “Program Failed”�
If you continue to receive this message after multiple attempts to program your blender,
see section 8 Warranty, for contact info�
To Next Page
Loading...
