EasyManua.ls Logo

Blendtec ES3 - Installation; Care and Cleaning; After Use Cleaning; Cleaning Tips and Cautions

Blendtec ES3
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
SECTION 4 - INSTALLATION
Place blender on a flat, clean, and dry surface�
Make sure a plug outlet is available within 2 feet (0�61 meters) of the blender motor
base�
Ensure the unit is turned off before plugging it into a separate receptacle� Blendtec
blenders are produced in either 100/120V or 220/240V power� An appropriate power
receptacle should be used - protection of at least 13 amps for 100/120V units and 6�5
amps for 220/240V
Make sure the electrical circuit is at least 13 amps or 6�5 amps depending on voltage�
We recommend that surge protection be placed between the receptacle and the
blender motor�
SECTION 5 - CARE AND CLEANING
5.1 AFTER USE CLEANING
1� Turn off main power switch and unplug motor before cleaning�
2� Clean the blender base by simply wiping the base and touchpad with a damp cloth
and water�
3� If needed, the drive socket can be cleaned using a toothpick or cotton swab�
5.2 CLEANING TIPS AND CAUTIONS
Do not use abrasives or stiff brushes to clean the blender motor base or jar as this
will dull or scratch the surface� Cosmetic damage is not covered by warranty�
Do not use a water jet of any kind to clean the blender base�
NEVER submerge the blender motor in water—THIS WILL VOID THE WARRANTY
5.3 JAR CARE INSTRUCTIONS
After each use, wash the jar and lid in hot soapy water� This can be accomplished by
filling the jar with 1-2 cups (237 ml) of warm water and blending a drop of dish soap
on low speed with the lid in place for one cycle�
Do not soak the jar in water for any extended period of time as this may shorten the
life of the jar bearing�
If the jar is being stored upside down, shake excess water from the jar so no water
collects around the drive shaft�
The jar may be washed in a dishwasher if placed on the top shelf� It is recommended
the “Heated Drying” option be turned off�
Sanitize the jar periodically by filling the blender jar with a sanitizer diluted according
to manufacturer’s specifications� Bleach, properly diluted, can be used as a sanitizer�

Related product manuals