Blocks ZERO - Printer and Print Profile Configuration

13
USER GUIDE MANUAL DE UTILIZAÇÃO ZERO
Attention: Copy and Paste the following text in the respective boxes for Start G-code and
End G-code (but only for the Printer tab, not for the Extruder tab):
Start G-code:
;Sliced at: {day} {date} {time}
;Basic settings: Layer height: {layer_height} Walls: {wall_thickness} Fill: {ll_density}
;Print time: {print_time}
;Filament used: {lament_amount}m {lament_weight}g
;Filament cost: {lament_cost}
;M190 S{print_bed_temperature} ;Uncomment to add your own bed temperature line
;M109 S{print_temperature} ;Uncomment to add your own temperature line
G21 ;metric values
G90 ;absolute positioning
M82 ;set extruder to absolute mode
M107 ;start with the fan off
G28 X0 Y0 ;move X/Y to min endstops
G28 Z0 ;move Z to min endstops
G1 Z15.0 F{travel_speed} ;move the platform down 15mm
G92 E0 ;zero the extruded length
G1 F200 E3 ;extrude 3mm of feed stock
G92 E0 ;zero the extruded length again
G1 F{travel_speed}
;Put printing message on LCD screen
M117 Printing...
End G-code:
;End GCode
M104 S0 ;extruder heater off
M140 S0 ;heated bed heater off (if you have it)
G91 ;relative positioning
G1 E-1 F300 ;retract the lament a bit before lifting the nozzle, to release some of the pressure
G1 Z+0.5 E-5 X-20 Y-20 F{travel_speed} ;move Z up a bit and retract lament even more
G28 X0 Y0 ;move X/Y to min endstops, so the head is out of the way
M84 ;steppers off
G90 ;absolute positioning
;{prole_string}

2.1. Download to your computer the Blocks zero print proles provided by Blocks
2.2. In the top tabs in Cura software select: Settings » Prole » Manage Proles
2.3. Click the tab Import and select the desired proles to import to the software
2.4. After that you can choose the correct prole for the desired material and quality by
clicking Activate in the same menu or by clicking Settings » Prole and choosing the
desired prole immediately.
Installation03