Begin by connecting the power supply supplied with the kit into the power plug and into the
wall outlet. Then turn the printer on by clicking the white switch on the back of the machine.
04.1 Loading the lament
1. Press the selection button once, rotate until you select Filament and press it again.
2. Then select the Load option and press the button again.
3. Wait while the Hot End heats up to 220°C.
4. Insert the lament into the extruder pulling the hinge at the same time, and make sure
just above the extruder. (To learn
more about inserting the lament, see page 64 of the TIPS section of the Blocks Zero
assembly guide.)
5. Wait while the lament is routed along the PTFE tube in the Bowden.
6. After the lament begins to exit through the nozzle, the operator may choose to terminate
the process or wait for the machine to do it after thirty beeps.
Illustrated steps in the next page
Note: If there is a change in the lament color or material, we recommend that you allow this last step
to be taken until the machine has nished.
Extra: To see the process of loading the lament in video format go to the Blocks channel on YouTube or
follow the direct link below.
Blocks Zero – Load Filament: https://youtu.be/Aa7Mt6X2byY
Operation04
To Next Page
Loading...
