10-16
Reflectors
Standard reflectors include:
• Two 3” red mounted on side of body near rear.
• Two 3” red, mounted on rear of body.
• Two 3” amber right and left intermediate side reflectors.
Reflective Tape: One-inch minimum width strip around each emergency exit (roof hatch/pushout window when ordered). One-inch
wide strip of yellow reflective vinyl around the perimeter of the rear emergency door.
Rubrails
Four double-ribbed low profile 16 gauge steel applied rubrails are installed along both sides of the body, as follows: One below side
windows; one at seat (Passenger) level; one near the floor level; one at the bottom of the skirt. The window, seat, and floor rails extend
from the front bow to the rear corner radius. The skirt rail extends from the front bow on the right, or the front cowl post on the left, to
the rear bumper (interrupted at wheelhousing cutouts). Rubrails are secured with 1/4” screws - 20 x 5/8” with Torx drive heads. Layouts
may vary on options ordered.
Safety Equipment
Three reflectorized triangular roadside warning devices enclosed in a plastic storage container, secured to the floor near Driver. 5 lb fire
extinguisher in entrance door area. Two roof escape hatches mounted above aisle.
To Next Page
Loading...
