6-6
Pre-Trip Inspection: Exterior
Name:
Date:
ITEM
INSPECTION - Exterior Walk Around
Approach bus from the front to begin general exterior inspection
PASS FAIL
1 Condition of front bus markings such as the school bus sign, and reective markings. Clean windshield if needed.
2 Look for any leaning or twisting of the bus which may suggest tire problems, axle misalignment, or structural damage.
3 Crossing arm is properly secure and unbroken.
4 Check mirror brackets for secure mountings. Check for broken or cracked mirrors, and clean the mirrors if needed.
5 Look underneath the bus for any unusual conditions such as dangling harness wires, uid leakage or other debris.
6 Look at the ground underneath for signs of uid leakage, broken glass, or other debris.
7
Check the tires for proper ination, tread depth, and any signs of physical damage.
Normal tread wear should be uniform across the width of the tread.
8
Inspect the rim for bends or other damage. Check that all lug nuts are in place.
If the bus is equipped with oil lubricated axles, check the sight glass in the center of the hub for proper oil level.
9 Check the Stop Arm for any signs of physical damage.
10
Open the battery compartment door and inspect the 12V battery.
Check for corrosion on the battery terminals and for loose connections. Close the compartment and make sure it is secure.
11
Check overall view of the left side. Check that all markings are legible and in good condition, including emergency exit signs and
reective tapes. Check for broken windows and any other signs of vandalism. Check that all windows are clean.